Illustrative visualisation: a worker cleans a mould in an injection moulding machine with dry ice

Applications / Plastics production and moulds

Fine contours.
Deposits that do not belong in them.

Residues of release agents and material settle in the cavities and on the parting surfaces of moulds. Targeted dry ice cleaning can help where a hand tool is hard to get to.

Who it is for

What is usually
dealt with.

Plastics manufacturers and moulding shops, toolmakers and foundries.

  • Release agent residues on moulds
  • Polymer deposits in accessible cavities
  • Dirt on parting surfaces and fixtures

Where it may help

If a trial confirms suitability, fine contours can be cleaned without adding sand or another solid abrasive.

What we check in advance

The settings must respect the surface finish, geometry and temperature of the tool. We always assess hot cleaning and cleaning without removing the mould for the specific equipment.

Where to go next

Service, equipment,
or ice deliveries.

Cleaning as a service

We assess your photographs, check the approach and carry out the work at your site.

Find out more

Your own equipment

Do you clean regularly? We will go through machines, air and accessories.

Find out more

Dry ice deliveries

Pellets for cleaning, as a one-off or for regular operation.

Find out more

Other areas

Take a look
elsewhere too.

All sectors

The texts describe what the technology can do. We always check suitability against the surface and the conditions on site.

Dry Ice Cleaning website

Let’s start with your question

What can dry ice
do for you?

Tell us about your job. Together we will find the next step.

Base
Chebská 53, 356 01 Sokolov
Cleaning
We travel across the Czech Republic and the EU